Description Of Device / Spare Parts; Possible Faults - ATIKA UZT 250 Mode D'emploi

Description of device / spare parts

Nr. Denomination
1 Table section
1a Table section
2 Safety guard
3 Guide ruler
3a End cap
3b End cap
4 Clamping screw for mitre guide
5 Angle for mitre guide
6 Guide carrier
7 Clamping screw for guide carrier
8 Clamping screw for incline adjustment
8a Adjusting knob for incline adjustment
9 Hand wheel for pull device
10 Crank for height adjustment
11 Stop for incline adjustment
12 ON / OFF-switch
13 Motor protection
14 Front guide bar with ruler
15 Table top

Possible faults

Before each fault elimination:
− switch off device
− Wait until the saw comes to a stop.
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switch-
ing on or switches off during idle
running
Machine stops while cutting
Workpiece sticks when feeding
Burned spots at the cut areas
Order-No.
363806
363808
362824
363817
363820
363818
363815
363816
363823
363824
363834
363833
}
363835
-
363837
-
363843
363804
Possible cause
• Power failure
• Extension cable defect
• Motor protecting switch has tripped
• Motor or switch defect
• Saw blade sticks
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Ruler of the universal guide is not parallel to
the saw blade.
• Saw blade is unsuitable for the cutting task or
blunt
Nr. Denomination
16 Side guide bar
17 Saw blade (Ø 250/30 mm x 2,6/1,6, 48 T)
18 Splitting wedge
19 Extraction hose, long
20 Extraction hose, short
21 Adapter for extraction hose
22 Exhaust neck
23 Holder 1 for push stick
24 Holder 2 for push stick
25 Push stick
26 Clamping screw for universal guide
27 Guide bar
28 Thumb nut
29 Saw blade flange
30 Open-end wrench
31 Ring wrench
32 Hose clip
33 Universal guide (Nr. 3-7, 26-28)
34a Compression plate
Remedy
• Replace fuse
• Check cable, no longer use defect cable
• Switch motor back on after cooling
"Motor protection", page 20
• Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
• Remove bench profile section and remove
cutting box cover, remove cause
• Replace saw blade
• Allow motor to cool and proceed working with
less pressure
• Hold the workpiece firmly and switch the
motor off immediately. The have the saw
blade sharpened or renew
• Readjust the scale
• Replace saw blade or have it sharpened
25
Order-No.
-
363831
363829
363844
363845
363810
363811
-
-
362872
363822
363821
363846
363218
-
-
363846
363809
363828