Storage; Guarantee; Possible Faults - ATIKA KGSZ 305 N Notice Originale

Storage

Remove the mains plug from the socket.
 Store unused equipment in a dry, locked place out of the
reach of children.
 Before extended storage, please observe the following to
increase the service life of the device and to ensure smooth
operation:
 thoroughly clean the saw
 treat all movable parts with an environmentally friendly oil

Never use any grease!

Possible faults

Before each fault clearance
 Switch off device
 Wait for standstill of the saw blade
 Pull out power plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off
during idle running
No crosscut function
Saw blade jams while cutting
Burned spots at the cut areas
Saw vibrates
Chip outlet is clogged
Rotary table moves hard
Possible cause
 Power failure
 Extension cable defect
 Motor or switch defect
 Transport locking pin not removed
 Locking device for pendulum cover not opened
 Saw blade is dull
 Feed is too great
 Saw blade is not suitable for the work step or is
dull
 Saw blade is warped
 Saw blade not properly mounted
 No exhaust system connected
 Exhaust power too weak
 Chips under rotary table

Guarantee

Please observe the enclosed terms of guarantee.
Removal
 Check safety fuse
 Check cable, no longer use defect cable
 Have motor or switch checked by an
approved electrician or replaced by original
spare parts
 Pull out transport locking pin (5)
 Open locking device (17)
 Replace saw blade (36)
 Allow motor to cool and proceed working with
less pressure
 Replace saw blade
 Replace saw blade
 Mount saw blade properly
 Switch off saw, remove chips and connect
exhaust system
 Switch off saw, remove chips and increase
exhaust power (air velocity 20 m/sec at chip
exhaust neck.
 Remove chips
25