Environment Protection; Technical Specifications - Güde EM 1300 P Mode D'emploi Original

Commands:
Do not touch these parts to
avoid burns. Learn carefully
how the appliance works
before operating it.
Use protective gloves

Environment protection:

Dispose waste professionally
so as not to harm the
environment.
Any faulty and/or disposed
electric or electronic devices
must be delivered to
appropriate collection centres.
Package:
Protect against moisture
Interseroh-Recycling

Technical specifications:

Connection
Engine speed
Grass catcher capacity
Noise
Use protective glasses and
headphones.
Use safety shoes
Packing cardboard material
may be delivered to
collecting centres for
recycling.
This side up
Engine output
Cutting width
Weight
Training
Please read carefully the Operating Instructions and the
servicing instructions. Familiarise thoroughly with the
controls and proper using of the appliance. You must know
how the appliance works and how controls can quickly be
switched off.
Never let children work with the appliance. Never let an
adult person work with the appliance without proper
training.
Do not let any persons, especially small children and pets,
to the place of your work.
Be careful to prevent slipping or falling.
Use as designated
The electric mower has been designed to treat grass plots
and lawns in private spaces.
The appliance cannot be used for other works than those
for which it has been designed and which are specified in
the Operating Instructions.
Any other use will be considered a use in conflict with the
designation. The manufacturer will not be liable for any
consequential damage and injuries. Please be sure to
know that the appliance has not been designed for
industrial purposes.
Assembly (pic. B)
Mounting the handles (pic. B/3,4)
1. Insert the bottom part of the handle or the two
bottom parts in appropriate holes on the mower
so that the bottom parts of the handle snapped
in, i.e. fasten them using two socket-head
screws and washers (included in the supply),
depending on the model.
2. Move the cable strain relief eye above the upper
part of the handle.
3. Now attach the upper part of the handle to the
bottom part of the handle using screws and fly
nuts (included in the supply).
4. Attach the appliance cable to the upper and
bottom part of the handle using cable clamps.
Assembly of wheels/cutting height adjusting (pic. B/5)
1. Depending on the required cutting height, fit the
small front and big rear wheels in appropriate
holes. The same cutting height score needs to
be used for every wheel.
Grass catcher assembly (pic. B/2)
1. Assemble the grass catcher as shown in picture
B/2.
Operation
Rotating knife
Works/adjustment on the appliance only to be performed
when the engine is off, the appliance unplugged and
cutting knife in an idle condition.
11