BoomToneDJ Slim PAR 18tri3 Mode D'emploi page 15

⑥Mains input：Connect to supply mains power.
⑦Mains output：Connect to supply mains power for the next unit.
⑧DMX input: For DMX512 link, use 3-pin XLR plug cable to input DMX signal.
⑨DMX output：For DMX512 link, use 3-pin XLR plug cable to link the next
unit.
Button:
① MENU
② UP
③ DOWN
④ ENTER
⑤Signal indicator light
Note:
(1)In a period of time, if has not been buttons to press, the LED display
(2)Whenever there is a button press, delay 2 seconds will automatically
(3)No matter what the program in which a mode, as long as test to
DMX/SLAVE signal, and the program jump into DMX/SLAVE
mode. Since then, if detect no DMX/SLAVE signal, and the program
will automatically return to the original mode.
To go forward select menu or go back the last level menu
To go forward select menu or increase parameters
To go backward select menu or reduce parameters
Go into the next level menu
In DMX or SLAVE mode, if detected signals, the
Signal indicator light flashing
will disappear. Press any button to turn the display on again.
to save all the parameters.
15