Prior To Fi Rst Use; Unpacking The Device; Inserting/Changing The Battery; Assembling The Device - Vitalmaxx HP12528 Mode D'emploi

Prior to fi rst use
Before using the device for the fi rst time you must:
• Unpack the product contents,
• Insert the batteries in the workout computer,
• Assemble the device.

Unpacking the device

ATTENTION!
❐ Keep children and pets away from the packaging. Danger of suffocation exists!
Unpack all parts and make sure that the product contents are complete (see chapter "Product
contents") and check for any damages from transport. If you identify damages to the compo-
nents, do not use them (!), instead contact our customer service centre.

Inserting/changing the battery

You will need a 1.5 volt battery, type AA to operate the workout computer.
1. Open the battery compartment on the back of the workout computer.
2. Insert the battery. When inserting a battery, make sure the polarity is correct (+/-).
3. Change the battery as soon as the display begins to diminish.

Assembling the device

ATTENTION!
❐ Set up the device in a suitable area with adequate space on all sides.
❐ Before assembling the device, spread out a blanket or tarp to protect your fl oor.
• To facilitate assembly, a parts list and graphic overview of the screws, nuts, and washers
used including their respective part numbers from the parts list are provided in the chap-
ter "Product contents". The numbers provided in the fi gures of this chapter also refer to
the "Part number" category on the parts list.
• Use the tool for tightening the screws.
24