General Characteristics - Cembre RH50 Notice D'utilisation Et Entretien

1. GENERAL CHARACTERISTICS

– Application range: the head is suitable for compression of electrical connectors on conductors
– Crimping force: ................................................................................................................50 kN
– Max operating pressure: .............................................................................................700 bar
– Oil necessary (displacement): ....................................................................................13 cm
– Dimensions: length ........................................................................................................196 mm (7.7 in.)
width .........................................................................................................75 mm
– Weight: (without dies) ...................................................................................................1,6 kg
2. INSTRUCTIONS FOR USE
2.1) Setting
The head is equipped with a "self-lock" quick male coupler suitable for connection to a hydraulic,
pneumatic or electrical pump from the Cembre range.
2.2) Die insertion
– Select the appropriate die set for the connector.
– Open the latch (13) and release the upper die holder (12).
– Insert one die into the upper die holder (12) and one die into the lower die holder (19).
– Close the latch.
Ensure that the latch and the upper die holder are fully secured, otherwise damage may occur
during tool operation.
2.3) Die advancement
– Insert the conductor into the connector.
– Locate the connector between the dies at the desired crimp position.
– Operate the pump to advance the main ram (07).
Make sure that dies are exactly positioned on the area to be crimped; otherwise, re-open dies fol-
lowing instructions as per § 2.5 and position the connector again.
3
HYDRAULIC PRESSHEAD
up to .............................................................................................300 mm
(Ref. to Fig. 2)
RH50
ENGLISH
2
(600 MCM)
(6 sh ton)
(10,000 psi)
3
(0.8 cu. in)
(3 in.)
(3.5 lbs)