Programming The Remote - Sony RHT-G1000 Mode D'emploi

Programming the remote

You can program the remote to control non-Sony
components by changing the code. Once the
control signals have been memorized, you can
use those components as part of your system.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
CLEAR ENTER
m M .
X
H
1
Press AV ?/1 while holding down RM
SETUP.
The indicator lights up.
Note
• Press the RM SETUP button using a pointed
object.
2
Press the input button for the
component you want to control.
For example, if you are going to control a
DVD player, press DVD.
3
Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables on pages 12–14 for
information on the numeric code(s)
corresponding to the component and the
maker of the component (the first digit and
the last two digits of the numeric code
correspond to the category and the maker's
code respectively).
RM SETUP
AV ?/1
Input buttons
Numeric
buttons
-
ENTER
>
x
4
Press ENTER.
Once the numeric code has been verified,
the indicator slowly flashes twice and the
remote automatically exits the
programming mode.
5
Repeat steps 1 to 4 to control other
components.
To cancel programming
Press RM SETUP during any step. The remote
automatically exits the programming mode.
To activate the input after
programming
Press the programmed button to activate the
input you want.
If programming is unsuccessful,
check the following:
• If the indicator does not light up in step 1, the
batteries are weak. Replace both batteries.
• If the indicator flashes 4 times in quick
succession while entering the numeric code,
an error has occurred. Start again from step 1.
Note
• The indicator turns off while a valid button is pressed.
• In step 2, if several input buttons are pressed, only the
last pressed button is valid.
• In step 2, if you press TV ?/1, only TV VOL +/– ,
TV CH +/–, TV/VIDEO and WIDE buttons are
reprogrammed.
• In step 3, if an input button is pressed, the new input
is selected and the programming procedure returns to
the beginning of step 3.
• For the numeric codes, only the first three numbers
entered are valid.
To clear the memory of the
remote
To clear all programmes, do the following to
reset the remote to factory settings.
Press VOLUME –, ?/1 and AV ?/1 at the
same time.
The indicator flashes 3 times, then goes off.
continued
11
US