Naming Preset Stations - Sony RHT-G1000 Mode D'emploi

To listen to non-preset radio
stations
Use manual or automatic tuning in Step 2.
For manual tuning, press TUNING + or –
repeatedly.
For automatic tuning, press and hold TUNING +
or –. Press TUNING + or – to stop the automatic
tuning.
Tip
• If an FM program is noisy, press FM MODE so that
"MONO" appears. There will be no stereo effect, but
the reception will improve. Press the button again to
restore the stereo effect.
• To improve reception, reorient the supplied antennas
(aerials).

Naming preset stations

You can enter a name for preset station. The
name (for example, "XYZ") appears when the
station is selected.
Note that no more than one name can be entered
for each preset station.
1
Press TUNER/BAND repeatedly until
"FM" or "AM" appears.
The last station you received is tuned in.
2
Press PRESET + or – repeatedly to
select the preset station you want to
create an index name for.
3
Press TUNER MENU.
4
Press C/X/x/c repeatedly until "Name
In?" appears.
5
Press ENTER.
6
Create a name by using the cursor
buttons.
Press X/x to select a character, then press c
to move the cursor to the next position.
Letters, numbers, and other symbols can be
input for a radio station name.
If you make a mistake
Press C/c repeatedly until the character to
be changed flashes, then press X/x to select
the desired character.
To erase the character, press C/c repeatedly
until the character to be erased flashes, then
press CLEAR.
7
Press ENTER.
The station name is stored.
Tip
• You can check the frequency by pressing DISPLAY
repeatedly.
To change the AM tuning interval
The AM tuning interval can be set to either
10 kHz or 9 kHz.
To change the AM tuning interval, first tune in
any AM station, then turn off the system by
pressing "/1 on the system. While holding down
INPUT SELECTOR, press "/1 on the system to
turn on the power. If you change the interval,
AM preset stations will be erased.
To reset the interval, repeat the same procedure.
23
US