Advanced Settings; Programming The Remote For Tv Operation (Input Sync: Sony Tv Only) - Sony RHT-G800 Mode D'emploi

Advanced Settings

Programming the remote
for TV operation (Input
SYNC: Sony TV only)
If you connect a Sony TV, follow the steps below
to program the remote. The TV input will be
selected automatically (Input SYNC).
Note
• Do not use the HDMI control function while the Input
SYNC function is active.
For details, see the HDMI CONRTOL Guide of the
stand.
TV
(orange)
Input
buttons
(TV, DVD/
BD, SAT,
AUDIO)
1
Press TV (orange) while holding down
the input button (TV, DVD/BD, SAT,
AUDIO) for the component you want to
operate.
For example, if you are going to operate a
DVD player, press DVD/BD.
The input button you pressed flashes.
2
Check the table below for the remote
button number corresponding to the TV
input jack you have connected to, and
press the number.
The input button (TV, DVD/BD, SAT,
AUDIO) goes off when you press the
number button.
TV input jack*
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
VIDEO 5
VIDEO 6
VIDEO 7
VIDEO 8
COMPONENT 1
COMPONENT 2
COMPONENT 3
COMPONENT 4
HDMI 1
Number
HDMI 2
buttons
HDMI 3
HDMI 4
ENT
HDMI 5
VIDEO RESET (TV)
NONE
* TV input jack name may differ depending on
your TV model.
Tip
• Press 20 if you do not want to send signals to the
TV.
3
Press ENT.
The setting is completed after the input
button you pressed in step 1 flashes twice.
4
Repeat steps 1 to 3 to program the
remote.
Notes
• An error has occurred when the input button you
pressed in step 1 flashes five times. Perform this
process from step 1 again.
• The two digits entered last are valid.
Remote Button
(codes)
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
20
continued
29
US