Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Indication...
... lerts
When your alarm system is deactivated, the base unit will report the problem with the voice
message "beep, date, time, fire alarm, remote control n°".
... Faults
In order not to wake you up, alarms resulting from mains supply problems or dirty sensors
are shut down during the night. Any errors are corrected after daybreak within 10 minutes
G
i.e. 12 hours after the event.
B
Power supply fault on the detector:
Detector at the source
of the fault indication
Other wired
inter-connected
detectors
If the sound indication of the power supply failure occurs at an inappropriate time, it is possible to
postpone its occurrence for an 8-hour delay over a maximum 7-day period by pressing the test
key until the 1st beep is released. This is the time period available for replacing the Lithium battery.
Power supply fault on the control panel:
Following a system command, the control panel issues the following voice message: "beep,
fault, battery, detector X".
Red signal LED
White
indicates the state
indicator
of the detector
LED
the unit flashes once
every 5 sec.
-
Built-in audible alarm
the unit releases
-
2 fast beeps every 60 sec.
-
-
40
When a battery fault
becomes evident, the
detector continues to
function perfectly for
30 days. It is advisable to
replace the battery as soon
as possible.
Publicité
Chapitres
Table des Matières
