Indication; Alerts; Faults - hager S151-22X Guide D'installation

7. Indication...

7.1 ... Alerts

When your alarm system is deactivated, the base unit will report the problem with the voice
message "beep, date, time, fire alarm, remote control n°".

7.2 ... Faults

CAution: in order not to wake you up, alarms resulting from mains supply problems
or dirty sensors are shut down during the night. Any errors are corrected after daybreak
within 10 minutes i.e. 12 hours after the event.
Power supply fault on the detector:
indicates the state
Detector at the source the unit flashes once
of the fault indication
other wired
inter-connected
detectors
If the sound indication of the power supply failure occurs at an inappropriate time, it is possible
to postpone its occurrence for an 8-hour delay over a maximum 7-day period by pressing the
test key until the 1st beep is released. This is the time period available for replacing the Lithium
battery.
Power supply fault on the control panel:
Following a system command, the control panel issues the following voice message: "beep,
fault, battery, detector X".
Red signal LeD White
indicator
of the detector LeD
-
every 5 sec.
- -
Built-in audible alarm
the unit releases
2 fast beeps every 60 sec.
-
45
CAution: when a battery
fault becomes evident, the
detector continues to
function perfectly for
30 days. it is advisable to
replace the battery as soon
as possible.
GB