Programming - hager S151-22X Guide D'installation

Programming

Programming enables the smoke detector to be recognised by the control panel.
To programme the smoke detector, the control panel must be in installation mode. If it is not,
press:
master code
G
then press:
B
engineer installer code
Carry out the programming sequence described below:
q
then
1) Press then # on the
*
control panel keypad
You can record a personalised message to identify the fire detector by voice (see the Control
panel installation manual, § on Voice identification message).
panel does not need to be placed next to it. In fact,
we recommend you place the product at a short
distance from the control panel (at least 2 m away).
10 s max.
2) Press & hold the programming key 0
for 10 sec. until the control panel responds
During recognition programming, the product
to be programmed for use with the control
"beep, fire detector n° X"
34