Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing the detector
Testing the radio
link at the chosen
location
The control panel
must be in
installation mode in order
to effect this test (see
G
familiarisation).
B
Œ
Hold down the detector
programming key 0 or the
test key until the integral
alarm sounds:
correct : the control panel
q
confirms the radio link with a
voice message "beep, fire
detector n° X",
incorrect: no voice mes-
q
sage at all, go back to the
smoke detector at the con-
trol panel.
Put the control panel back
in user mode and press:
engineer installer code
Fixing
Standard fixing method
Œ
Install the base in the desired location, then mark the posi-
tion of the 2 fixing holes using a pencil (Ref. mark
Drill holes using a 5 mm Ø drill bit.
Ž
Fix the base using appropriate pins and screw.
Fixing with flush-mounting box
For boxes of 60 mm diameter: use holes marked
q
For boxes of 85 mm diameter: use holes marked
q
Fix the base using suitable screws.
q
For passing the
interconnecting cables,
remove the 2 fixing spacers
and insert them between
the ceiling and the
mounting base by covering
the 2 selected fixing holes.
Optional locking of the detector on the mounting base
Optional locking is designed to prevent unauthorized dis-
mounting of the detector.
Using cutting pliers, cut the locking nipple.
Opening will now
be possible only by
means of a flat
blade screwdriver.
Locking nipple
36
60
60
Diameter 60 fixing holes
position in the
Diameter 85 fixing holes
or
).
5
.
.
5
Alignment
key test
Fixing
spacers
Publicité
Chapitres
Table des Matières
