Programming - hager S151-22X Guide D'installation

GB

3. Programming

Programming enables the smoke detector to be recognised by the control panel.
To programme the smoke detector, the control panel must be in installation mode. If it is not,
press:
master code
then press:
engineer installer code
Carry out the programming sequence described below:
then
Press then # on the
*
control panel keypad
You can record a personalised message to identify the fire detector by voice (see the Control
panel installation manual, § on Voice identification message).
10 s max.
Press & hold the programming key 0
for 10 sec. until the control panel responds
CAution: during recognition programming,
the product to be programmed for use
with the control panel does not need to be
placed next to it. in fact, we recommend
you place the product at a short distance
from the control panel (at least 2 m away).
"beep, fire detector n° X"
38