Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.
When the heating plate is heated to the require temperature, you can begin to
griddle food, When the food is done, take out the food lest the surface of the hot
plate will be scratched.
8.
After use, turn the switch of the appliance clockwise until a ticking sound is
heard and turn off the control valve of the liquid gas storage tank.
iV. Maintenance inStrUctionS
Maintenance
1.
The appliance can be cleaned with a soft cloth after use, and be wiped with
neutral detergent if necessary.
2.
The residual oil collected in the oil container on the top of the cabinet should be
cleaned up regularly.
3.
Be sure not to wash the appliance with water.
4.
The appliance should be cleaned kept in well-ventilated place without corrosive
gas if it will not be used for a long period of time.
5.
When using the appliance, be sure not to touch the hot plate with hands to avoid
scald due to high temperature.
6.
When the appliance is not in use, turn off the gas supply valve to avoid accident.
In case of breakdown, be sure not to disassemble the appliance by yourself.
Please send it to the special repaire shops or the dealers.
warning
1.
This appliance used low-pressure control valve for gas supply. The use of high-or
medium-pressure valves is prohibited.
2.
Be sure not to wash the appliance with water! Otherwise, the gas device may
have problems due to damp.
3.
Placement of inflammables or explosives in the cabinet or around the appliance is
strictly prohibited!
4.
When the work is done, turn off the switch and the gas supply valve of the
appliance immediately!
V. rePlacing FaUlty coMPonentS
Diagnosis of Common Fault
The above types of faults are for reference only. In case of fault, stop using the
appliance immediately and contact professional maintenance workers for repair or
contact the supplier as possible.
20
Fault
Cause Analysis
Failure in ignition
•
There is no gas supply
or the gas pressure
does not fit.
•
The switch of the
appliance is damaged.
•
the ignition electrode
has loosened and
shifted.
The fire goes out
•
The fire detector has
immediately after
dislocated or the lead
successful ignition
has dropped.
•
Lack of oxygen for
combustion
•
the gas pressure is
too low or the gas
supply is insufficient.
Vi. tecHnical detailS
Sheet 1
Model
Qty oF
Plate SiZe
BUrnerS
(WXD)
RCGL65
2
600x400mm
RCGL75
3
750x400mm
rcgl110
4
1100x400mm
Solution
•
Check the air inlet
and the gas pressure.
•
Replace the switch of
the appliance.
•
Adjust the position of
the ignition electrode
and make it firm.
•
Adjust the fire
detector to allow the
flame to go red.
•
Maintain good
ventilation.
•
Check and replace
the gas, or turn up
the gas supply valve.
ProdUt SiZe
reMarK
(WXDXH)
650x580x350mm
800x580x350mm
1150x580x350mm
21
Publicité
Table des Matières
