Nuova Simonelli MUSICA Manuel D'instructions page 18

+
This appliance is for profes-
sional use only.
+
The operating temperature
must be within the range of [+5,
+35]°C.
+
At the end of installation, the
device is switched on and taken
to rated operating conditions,
leaving it in a state in which it is
"ready for operation".
The device is then switched off
and the whole hydraulic circuit
is bled of the first lot of water in
order to remove any initial
impurities.
The device is then refilled and
taken to rated operating condi-
tions.
After reaching the "ready for
operation" condition, the fol-
lowing dispensing operations
are carried out:
- 100% of the coffee circuit
through the coffee dispenser
(for more than one dispenser,
this is divided equally);
- 100% of the hot water circuit
through the water dispenser
(for more than one dispenser,
this is divided equally);
- opening of each steam outlet
for 1 minute.
At the end of installation, it is
good practice to draw up a
report of the operations.
WARNING
Before using the machine, read this
manual in its entirety or, at the very
least, read the safety and set up
instructions.
16
+
There are some basic rules for
the use of any electrical appli-
ance.
In particular:
• never touch the unit with wet
hands or feet;
• never use the unit with bare
feet;
• never use extension cords
in areas equipped with baths
or showers;
• never pull on the power sup-
ply cord to unplug the unit;
• never leave the unit exposed
to atmospheric agents (rain,
direct sunlight, etc.);
• never let children, unauthor-
ized personnel or anyone
who has not read this man-
ual operate the unit.
+
Before performing any sort of
maintenance, the authorized
technician must turn off the
unit and unplug it from the
mains.
+
Before cleaning the unit set it in a
state of "0" energy: that is,
"MACHINE SWITCHED OFF AND
UNPLUGGED". Follow the instruc-
tions given in this manual care-
fully.
+
For cleaning and maintenance
please refer to chapter 7.
+
In case of breakdown or poor
function, turn off the unit. Never
tamper with the unit.
Contact only professionally quali-
fied personnel.
Fig. 3
Only the manufacturer or an
authorized service center can
make repairs and only using origi-
nal spare parts.
Non compliance with the above
can compromise machine safety.
+
Upon installation, the qualified
electrician must arrange for an
omnipolar switch, as called for by
the safety regulations in force and
which performs a complete dis-
connection under the conditions
of over tension category III. When
open, the contacts must be 3 mm
Fig. 4
or more apart.
Fig. 5