Nolan N91 EVO Sécurité Et Instructions D'utilisation page 14

WARNING!
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
replaced. Regularly check the correct stretching of the inner visor to prevent the same from
moving and scratching both surfaces. If the helmet visor fogs up and/or condensation forms
between the visors, check both for system correct assembly and stretching. An excessive
and early stretch of the inner visor may result in excessive adherence against visor surface
and/or permanent deformations with subsequent inability to perform following adjustments
correctly. The extended use under special weather conditions may reduce system perform-
ance and result in partial fogging and problems of condensation on the inner visor. In this
case, remove the inner visor from the helmet visor and dry it with dry and lukewarm air to
restore system efficiency. Intense sweating /breathing, the use under particular weather con-
ditions (low temperatures, and/or high humidity and/or sudden changes in temperature or
heavy rain) and intense and prolonged use may affect the performance of the system and
cause the fogging or formation of condensation on the inner visor. In such cases, after using
the helmet and to restore the system efficiency, remove the inner visor from the helmet visor
and let it dry with dry and lukewarm air. The same procedure must be applied to the helmet,
in order to dry out humidity in case it has formed up as a consequence of the conditions
described above.
2 PINLOCK ® INNER VISOR DISASSEMBLY
2.1 Remove the visor equipped with Pinlock
2.2 Widen the visor and release the Pinlock
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the Pinlock
with neutral liquid soap. Remove the soap under running water. Dry the inner visor with dry
and lukewarm air without wiping it. To keep the features of the inner visor in good conditions
over time, let the helmet dry in a ventilated and dry place with the visor open after use. Keep
it away from heat sources and store it in a place away from direct light.
• VISION PROTECTION SYSTEM (VPS)
The exclusive inner VISION PROTECTION SYSTEM (VPS) is a LEXAN
moulded sun screen with scratch-resistant/fog-resistant treatment. Very simple and practical
to use. Just lower to activate it or lift to remove it from the field of vision.
It is useful in all sorts of situations, both on long journeys out of town and shorter town trips.
Moreover, the innovative fastening system allows you to assemble and disassemble the sun
screen without the need for any tools for ordinary maintenance and cleaning operations.
VPS operation
The VPS mechanism allows activating the sunscreen by simply lowering it until it partially
covers the visor field of vision. In this way, the desired light transmittance reduction is
achieved. At any time, independent of the visor, the VPS can be deactivated with a simple
movement and easily pulled up to restore the normal conditions of visibility and protection
guaranteed by the approved helmet visor.
To activate the VPS, push the slider forward (Fig. 9 A) until you hear the click, which means
the slider and VPS are correctly in place.
To activate the VPS, push the slider towards the back of the helmet (Fig. 9 B) until you hear
the click, which means the slider and VPS are correctly in place.
(*) LEXAN is a trademark of SABIC.
® inner visor from the visor. Using a damp and soft cloth, gently clean it
® inner visor.
® inner visor from the pins (Fig. 7).
14
™
(*) - polycarbonate