Installation; General - Hatco HRDW Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Heated Rice Drawer Warmers are shipped with most
components pre-assembled. Care should be taken when
unpacking the shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAzARD: Locate the unit a minimum of 1" (25 mm)
from combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could occur.
CAUTION
Locate unit in an area that is convenient for use. The
location should be level and strong enough to support the
weight of the unit and contents.
NOTICE
Do not lay unit on front or back side. Damage to unit could
occur.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
ImPORTaNT OWNER INFORmaTION section for
details.
2. Remove tape and protective packaging from all surfaces of
unit.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F (21°C).
avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, exterior doors).
• make sure the unit is located on solid, level flooring.
• make sure the unit is at the proper height in an area
convenient for use.
4. Remove any pans or lids from the drawers and/or on the
unit.
5. Place a piece of cardboard on the work surface to prevent
marring the finish of the unit.
NOTICE
Do not lay unit on the front or back side or damage to the
unit could occur.
6. Carefully lay the unit on the cardboard on its left or right
side (requires two people).
7. Install the front 4" (102 mm) rigid casters.
NOTE: The rigid casters must be installed at the front of the unit
and with the wheel facing toward the front.
a. align the holes on the caster plate with the holes on the
base of the unit.
b. Secure the caster using the supplied screws. Tighten
securely.
8. Install the rear 4" (102 mm) swivel casters.
NOTE: The swivel casters must be installed at the rear of the
unit.
a. align the holes on the caster plate with the holes on the
base of the unit.
b. Secure the caster using the supplied screws. Tighten
securely.
Installing Casters
Unit may tip if casters are not installed correctly. Rigid
casters must be installed at the front and the wheel must
face toward the front.
Front
of Unit
The front Rigid Casters
must be installed with
the wheel toward front.
Caster Orientation
9. Return the unit to the upright position (requires two people).
10. Plug the unit into an electrical receptacle of the correct
voltage, size, and
SPECIFICaTIONS section for details.
6
English
Rigid Caster
Screws
CAUTION
Side View
plug configuration.
Form No. HRDWm-0515
Swivel
Caster
See the