Installation; General - Hatco HDWD Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Hatco Drawer Warmers are shipped with most components
pre-assembled. Care should be taken when unpacking the
shipping carton to avoid damage to the unit and components
enclosed.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAZARD: Locate unit a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances are not
maintained, combustion or discoloration could occur.
NOTICE
Do not lay unit on the front or back side. Damage to the
unit could occur.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of unit.
3. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is located on solid, level flooring or
in sturdy cabinetry.
• Make sure the unit is at the proper height in an area
convenient for use.
4. Apply a bead of National Sanitation Foundation-approved
sealant in the corner between the unit and the countertop.
• If installing optional legs or casters do NOT seal the unit
to the countertop. Refer to the appropriate installation
procedure in this section.
Installing Legs
1. Remove the plastic bag containing the four legs from the
drawer of the unit.
2. Carefully lay the unit on its side (requires two people).
3. Install the legs.
a. Thread a leg into the hole located at one corner of the
unit.
b. Hand-tighten the leg until snug. Do not over-tighten.
c. Repeat steps a and b for the remaining three legs.
4. Return the unit to its upright position (requires two people).
If the unit is not level or rocks, turn the adjustable tip of the
appropriate leg to level the unit.
Installing Casters
1. Remove the plastic bag containing the four casters from
the drawer of the unit.
2. Carefully lay the unit on its side (requires two people).
3. Install the casters.
a. Align the four holes on the caster plate with the four
holes in the bottom of the unit at one corner of the unit.
b. Install a bolt through each of the holes in the caster plate
and into the bottom of the unit. Tighten securely.
c. Repeat steps a and b for the remaining three casters.
4. Return the unit to its upright position (requires two people).
Caster Installation
6
English
Shorten
Lengthen
Adjustable
Tip
Leg Installation
Caster
Plate
Bolt
Form No. HDWDM-0118