Before Use; Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil Black Label CP-2 Mode D'emploi

3 Before use

3.1 Unpacking

3 Before use
ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of
no-longer-needed packaging material properly.

3.2 Selecting the proper nozzle

2 3
1
2
3

3.3 Assembly

A
1
4
A
5
12
*
6
4
5
A B
B
1
B
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
„
The crevice nozzle and the furniture brush are included as
accessories in the scope of delivery besides the floor nozzle (Fig. 2/1).
- Crevice nozzle (Fig. 2/2): Use this to vacuum dust from hard to
reach places.
- Furniture brush (Fig. 2/3): Use this to vacuum dust off objects that
*
have sensitive surfaces.
7
- Parquet brush (Fig. 2/4): Its long bristles make it especially suitable
for cleaning delicate surfaces (e.g. parquet and laminate floors).
- Long flexible crevice nozzle (Fig. 2/5): Use this to vacuum dust
from distant, hard-to-reach places.
„
Optionally available* (*i. e. included in the scope of delivery depend-
ing on model and features) are also:
- Turbo brush (Fig. 2/6*): is used to vacuum non-sensitive carpets,
runners, mats, and the like.
- Mini turbo brush (Fig. 2/7*): is used to vacuum non-sensitive uphol-
stery, runners, mats, and the like.
ATTENTION:
Our (mini) turbo brush can only be used to vacuum surfaces that
are not sensitive. Do not clean any floors or objects with the (mini)
turbo brush that you would not clean without a second thought with a
conventional brush. Therefore, do not clean sensitive or polished floor
surfaces with the (mini) turbo brush. Nor should you clean furniture, sen-
sitive carpets, upholstery, covers, or any material with a sensitive texture
with the (mini) turbo brush. If in doubt, refrain from using the (mini) turbo
brush. In every instance observe the instructions for care and cleaning of
the respective manufacturer.
2. Push the accessory bracket onto the telescopic tube as shown, or onto
the handle (Fig. 3/A).
3. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not
connected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or of the handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
C
the vacuum cleaner until you hear and feel it locking into place.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.