Before Use; Unpacking; Selecting The Proper Nozzle; Assembly - Dirt Devil Magnum PR Mode D'emploi

3 Before use

3.1 Unpacking

ATTENTION:
Always transport or ship the appliance in its original packaging to avoid
damage. Keep the packaging for such an event. However, dispose of
no-longer-needed packaging material properly.

3.2 Selecting the proper nozzle

1
2
3

3.3 Assembly

A
1
4
A
5
12
2
4*
5*
A B
B
1
B
3 Before use
1. Unpack the appliance and all its accessories.
2. Check that the contents are intact.
NOTE:
Immediately contact your dealer if you have found damage resulting
from transport.
1. Select the nozzle according to the surface to be cleaned:
3
„
Floor nozzle (Fig. 2/1): It can be used everywhere and, thanks to its
switch, can be used equally well on carpets and hard floors.
„
Crevice nozzle (Fig. 2/2): Use this to vacuum dust from narrow, hard-
to-reach places.
„
Furniture brush (Fig. 2/3): Use this to vacuum dust off objects that
have sensitive surfaces.
„
Parquet brush (Fig. 2/4*, optional): Its long bristles make it especially
suitable for cleaning delicate surfaces (e.g. parquet and laminate floors).
„
Turbo brush (Fig. 2/5*, optional): This has a rotating brush head and
is most suitable for deep cleaning carpets thoroughly. The brushing action
also raises the carpet pile.
ATTENTION:
Our turbo brush (optional) serves solely to vacuum non-sensitive car-
pets, runners, doormats, and the like. Do not clean any objects with the
turbo brush that you would not clean without a second thought with a
conventional brush. Therefore, do not clean furniture, or materials with a
delicate texture, nor any other high-quality or polished substrates with
the turbo brush. Otherwise material damage might occur. If in doubt,
refrain from using the turbo brush. In every instance observe the instruc-
tions for care and cleaning of the respective manufacturer.
2. Push the accessory bracket onto the telescopic tube or handle as
shown (Fig. 3/A).
3. Push nozzles not in use onto the stubs of the accessory bracket (Fig. 3/
B).
4. Keep the other nozzles safe and inaccessible to children.
WARNING:
Danger of injury! Only attach the nozzles if the appliance is not con-
nected to the power supply. The cylinder vacuum cleaner could be
switched on by accident.
ATTENTION:
Before vacuuming, make sure that the fitted nozzle suits the surface to
be cleaned. Also observe the flooring manufacturer's recommendations.
1. Attach the selected nozzle to the bottom end of the telescopic tube
(Fig. 4/A1) or handle (Fig. 4/B1).
2. Insert the end of the suction hose into the intake opening (Fig. 5/A) of
C
the vacuum cleaner until you hear and feel it locking into place. Make
sure that the latch points downwards.
If using the telescopic tube:
3. Insert the handle into the upper end of the telescopic tube (Fig. 5/B).
4. Adjust the length of the telescopic tube (Fig. 5/C). Press down the re-
lease latch on the tube to do this. Then extend the telescopic tube to
the desired length. Let go of the release catch while pulling until it locks
in place. You will hear a distinct click.