Mantis ComposTumbler CT02001 Guide D'assemblage page 6

STEP 8: Gear Drive Assembly
Select:
• 1 Drive Support (item 19)
• 1 Drive Gear (item 24)
• 1 Drive Handle Assembly (from step 7)
• 1 Cotter Pin (item 25)
1) Push the Drive Gear through the tube in the Drive Support
with the Gear on the inside of the Support.
2) Insert the bar of the Drive Handle through the Drive Gear.
3) Slide the Cotter Pin through the hole in the end of the Drive
Handle bar.
4) Use pliers to bend the legs of the Cotter Pin to keep it in
place.
STEP 9: Gear Drive Positioning
Select:
• 1 Gear drive Assembly (from step 8)
• 1 Drum Assembly (from steps 1-6)
1) Guide the Drive Gear into the Gear recess of one Endcap.
It may be necessary to pull the ends or the Drive Support
slightly apart to position it correctly.
STEP 10: Frame Leg Assembly
Select:
• 1 Drum Assembly with Gear Drive (from steps 8-9)
• 2 Frame Legs (item 22)
• 2 Stub Axles (item 29)
• 2 Bolts, 3/8" x 4" (10 mm x 10 cm) (item 32)
• 2 3/8" Fender Washers (item 30)
• 2 3/8" Nuts (item 31)
1) From inside the Drum, position a Stub Axle into the center
hole of the Endcap while at the same time, adjusting the
end of the Drive Support so that it fits into the channel of
the Stub Axle.
2) Position a Frame Leg into the end of the Drive Support
until the holes align.
3) Now push one of the 3/8" x 4" (10 mm x 10 cm) Bolts
through both parts and into the center hole of the Stub Axle.
4) Working again inside the Drum, place one 3/8" (10 mm)
Fender Washer over the end of the 3/8 x 4" Bolt, against the
top flange of the Stub Axle and secure it using a 3/8"
(10 mm) Locknut.
5) Repeat this step for the other Stub Axle and Frame Leg.
6