Mantis ComposTumbler CT02001 Guide D'assemblage page 5

STEP 6: Latch Attachment
Select:
• 2 Latches (item 8)
• 2 Latch Hooks (item 7)
• 8 #10 Bolts (silver) (item 10)
• 8 #10 Flatwashers (item 11)
• 8 #10 Lockwashers (item 12)
• 8 #10 Nuts (item 13)
• 1 Drum Assembly
• 1 Door Assembly
1) Attach the Latches on one side of the Door open ing with
the hooks toward the opening using: 1 #10 Bolt (silver),
1 #10 Flatwasher, 1 #10 Lockwasher and 1 #10 Nut
on each side of both Latches. Be sure the flatwasher,
lockwasher and nut are on the underside of the panel
in the recess, with the Bolt on top of the Latch. Use the
regular screwdriver and 3/8" (10 mm) wrench to tight en
all Latch mounting fasteners.
2) Position the Latch Hooks on the other side of the panel
opening with the hook ends toward the open ing. Secure
them the same way as the latches, but make the fasteners
only hand tight.
3) Position the Door Assembly in place on the panel. Fit
the notches on one end of the Door into the Hooks on
the panel, and the hooks of the Latches into the notches
on the other side of the Door. Close the latches to check
their tension; they should "snap" closed, but should not
be too difficult to open. Loosen and adjust the Latch
Hook fasteners to get the proper tension, then tighten
them with the regular screwdriver and 3/8" (10 mm)
wrench.
4) Remove the Door Assembly and set it aside until you've
completed the next steps.
STEP 7: Drive Handle Assembly
Select:
• 1 Drive Handle (item 20)
• 1 Grip (item 26)
• 1 Grip Cap (item 27)
• 1 #6 Screw (item 28)
1) Slide the Grip onto the end of the Drive Handle.
2) Push the stem of the Grip Cap into the end of the Drive
Handle, aligning the holes.
3) Secure the Grip Cap to the end of the Drive Handle with
the #6 Screw. Tighten the Screw until just snug. Note:
The head of the Screw will be in the hole of the Drive
Handle, locking the Grip Cap in position.
5