Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 4: Second Encap Assembly
Select:
• 1 Endcap (item 3)
• 3 Tie Rods (item 4)
• 6 Acorn Nuts (item 14)
1) Position the second Endcap over the open end of the
Drum Assembly, lining up the Endcaps so that the screens
are nearly opposite each other. The center mixing fin
in the drum fits into the alignment slot near the screen.
(Note: The mixing fins on the ends of the segments will
not fit in the alignment slots because the drum panels
extend beyond the alignment slots in this section of the
drum.) Be sure the Drum Assembly is com pletely fitted
into the Endcap rim all around.
2) Thread an acorn nut onto the end of one Tie Rod just until
the nut holds (about two turns). Insert the other end of the
Tie Rod through one of the small holes near the screen in
the top Endcap and run the rod down through the opposite
hole in the bottom Endcap.
3) Thread a second acorn nut onto the exposed end of the
Tie Rod. If there is not enough exposed thread to start the
nut or if the rod will not go all the way through the drum,
double check to make sure the drum edges are fitted all
the way into the rim of the Endcaps. If there is a problem,
loosen the acorn nut on the first end of the tie rod or press
firmly on both Endcaps to seat them fully.
4) Repeat steps 2 & 3 with the remaining tie rods and acorn
nuts, connecting the two remaining pairs of holes near
the Door Opening. When all three tie rods have been
positioned and secured, tighten all acorn nuts using an
adjustable wrench at one end and a 7/16" (11 mm) wrench
at the other. Note: Do not over tighten
STEP 5: Door Assembly
Select:
• 2 Aerator Bases (item 5)
• 2 Aerator Caps (item 6)
• 2 Bolts, 1/4" x 3 1/4" (6 mm x 8.25 cm) (item 16)
• 2 Wing Nuts (item 15)
• 1 Door (item 9)
1) Position one Aerator Base, with the curved edge and square pins inward, on the outside of the
Door.
2) Insert one 1/4" x 3-1/4" (6 mm x 8.25 cm) bolt through the Aerator Base and hole in the Door.
3) Slip one Aerator Cap over the Bolt on the inside of the Door, threading a Wing Nut onto the end
of the bolt until hand tight. Be careful not to over tighten the assembly.
4) Repeat the above steps with the second Aerator Base and Cap over the second hole in the Door.
5) Check both aerators to make sure the curve of the door when it's in place on the drum and the
contour of the outer portion of the aerator match. Apply slight pressure on the wing nuts to hold
the assembly firmly in place. Be careful not to over tighten.
4
Publicité
Table des Matières
