Wash Cycle Information
The cycle times in this Use and Care Manual are based on normal soil loads and 120°F incoming water and
will vary based on your actual conditions.
cycle time
cycle time with Half Load option
cycle time with Sanitize option
water consumption
wash temperature
rinse temperature
Note: Only sanitizing cycles have been designed to meet the requirements of 6 for soil removal and sanitiza-
tion efficacy. There is no intention, either directly or indirectly, to imply that all cycles have passed sanitiza-
tion performance tests.
Operating the Dishwasher
Start the dishwasher
1
Open the door (top controls only) and press the [On/Off] button. The LED of the last selected cycle flashes.
Select a cycle and desired options.
2
3
Press [Start] and close the door (top controls only) to begin the cycle.
Cancel a cycle
Open the door just far enough to expose the control panel (top controls only). Be careful of hot water
1
that may splash out.
Press and hold the [Start] button for approximately 3 seconds until the display reads "0:01".
2
3
Close the door (top controls only). Wait about 1 minute while the dishwasher drains.
Open the door (top controls only) and press the [On/Off] button.
4
Interrupt a cycle
Open the door just far enough to expose the control panel. Be careful of hot water that may splash out
1
(top controls only).
Press the [On/Off] button to turn the unit off.
2
To resume the cycle, press the [On/Off] button and close the dishwasher door (top controls only).
3
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
To change the setting:
Open the door (top controls only) and press the [On/Off] button.
1
2
Hold down the "A" button (see page 4) and press [Start] until the display indicates "H:00".
Release both buttons.
3
4
Press the "A" button until the display shows "r:04".
Press the "C" button to select the desired setting.
5
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
6
Press [Start] to save the setting and close the door (top controls only).
Table 3 - Wash Cycle Information
Heavy
110-125 min
105-129 min
110 min
95-105 min
125-145 min
120-140 min
16.7-21.9 L
11.1-20.0 L
4.4-5.8 gal
66-71°C
151-160°F
72°C
162°F
Auto
Normal
95-119 min
90-99 min
115-130 min
8.2-16.3 L
2.9-5.3 gal
2.2-4.3 gal
55-66°C
50-55°C
131-151°F
122-131°F
70°C
65-69°C
158°F
149-156°F
Rinse
9 min
--
--
4.0 L
1.0 gal
incoming
incoming
incoming
incoming
9