Spark Plug Service - GGP WBE Série Manuel D'utilisation

a) Clean around the filter cover (1).
b) Remove the cover (1) by unscrewing the two
knobs (2).
c) Remove the filtering element (3).
d) Blow compressed air from the inside to
remove dust and debris.
IMPORTANT
Do not use water, petrol,
detergents or any other products to clean the
filtering element.
g) Put the filtering element (3) back in place,
close the cover (1) and screw the knobs (2).
6.6

SPARK PLUG SERVICE

a) Remove the spark plug (1) using a spark plug
socket wrench (2).
b) Clean the electrodes (3) with a metal brush
and remove any carbonaceous build-up.
c) Using a thickness gauge (4), check for the
right gap (0.6 - 0.8 mm) between the elec-
trodes.
d) Install the spark plug (1) and tighten with a
socket wrench (2).
Replace the spark plug if the electrodes are
burnt or if the porcelain is broken or damaged.
WARNING!
!
Fire hazard! Do not check
the ignition system with spark plug remov-
ed.
IMPORTANT
Use only spark plugs of the
recommended type (see 8.1).
7
EN