Cleaning And Care - Bosch MSM78 Série Mode D'emploi

en
- If using the carrier disc with cutting
insert: Only handle and remove
the carrier disc using the recessed
handles. Rotate the carrier disc and
carefully push out the insert from the
underside (fi g. F).
If the recessed handles make it
diffi cult to remove the carrier disc,
you can take remedial action using a
dry cloth or paper towel.
• Removing the whisk:
- Remove the whisk from the drive
unit.
- Press the release buttons and
remove the drive unit from the basic
unit.
• Clean all parts, see »Cleaning and care«.

Cleaning and care

Risk of electric shock:
Never immerse the basic unit
in water and do not clean in the
dishwasher. Do not use steam cleaners.
This may damage surfaces.
Do not use abrasive cleaning agents.
When processing carrots or red
cabbage, for example, the plastic
parts may become stained. These
stains can be removed using a few
drops of cooking oil.
Cleaning the basic unit
• Unplug the mains plug.
• Wipe the basic unit with a damp cloth
and rub dry.
• The mixing beaker can be cleaned in the
dishwasher.
• Place the mixer foot in the dishwasher
in an upright position (mixing foot blade
at the top) or clean with a brush under
running water.
• Allow the mixer foot to dry in an upright
position, to allow water to drain out.
14
Cleaning the multi-function
accessory and tools
Risk of injury due to sharp blade.
Only handle the universal blade using
the plastic handle. Only handle the carrier
disc using the recessed handles provided.
Caution:
Never immerse the drive unit of the multi-
function accessory in water and do not
put it in the dishwasher. The detachable
shaft can be briefl y rinsed under running
water.
• The bowl, pusher, cutting inserts, carrier
disc for disc inserts and blade are all
dishwasher-proof.
• Wipe the drive unit with a damp cloth or
rinse briefl y under running water.
Cleaning the whisk
Caution:
Never immerse the drive unit in
water and do not clean in the dishwasher
or under running water.
• The whisk can be washed in the
dishwasher, the drive unit should be
wiped using a damp cloth.
Troubleshooting
Fault Remedy
Appliance swit- The overload safety
ches off during device has been
operation or the activated.
speed display •
begins to fl ash.
•
•
Robert Bosch Hausgeräte GmbH
Switch off the
appliance and
disconnect the
mains plug.
Allow the
appliance to cool
for approx. 1 hour
to deactivate
the overload
protection.
Switch the
appliance back on
again.