Trans Port; Load Ing And Trans Por Ta Tion - Ammann 11003438 Série Traduction Du Mode D'emploi Original

4.1 Load ing and trans por ta tion

Only use suf fi ciently strong and se cure load ing
ramps when load ing.
Check the con tact points (frame, lift ing rings) be -
Danger
fore use for dam age and wear. Im me di ately re -
place dam aged parts.
Se cure the ma chine against roll ing or slip ping off
and against tip ping over.
En sure that no per sons will be en dan gered.
When load ing, lash ing down and lift ing the ma -
chine al ways use the pro vided lift ing points.
Per sons are in dan ger, if they
• go near swing ing loads or
• stand un der swing ing loads
Af ter load ing lock the tow bar.
Af ter be ing loaded on to the means of trans por ta tion, the ma -
chine should be lashed in place. The lash ings should be at tached
to the front or rear rings in the arms (1).
Use the cen tre-of-grav ity sus pen sion point (2) on the hoop guard
in or der to lift the ma chine.
60

4. Trans port