Frequently Asked Questions; Technical Data; Optional Accessories - Marmitek Powermid XL Guide Utilisateur

5. FREQUENTLY ASKED QUESTIONS

• I n a few cases, the Receiver may be disrupted by interference and cannot, therefore, pick
up the signals it receives. If this is the case the red light will be continuously illuminated
and the Receiver must be relocated. This interference is caused by equipment in the
vicinity such as dimmers, energy-saving light bulbs, IR alarms and so on. Direct sunlight
can also disrupt the Receiver.
• P owermid XL does not work with remote controls which use High Frequency signals (such
as B&O)
Do you have other questions that have not been resolved by the above information?
Please go to www.marmitek.com

6. TECHNICAL DATA

Range:
Power:
Frequency:
Dimensions:
Frequency range:
IR reception range:

7. OPTIONAL ACCESSORIES

IR EYE (Art. no. 09682)
The IR Eye extends the IR signal of your remote control in combination with the Powermid
XL™. Using the infrared extender, you can operate your A/V equipment even when it is in a
closed cupboard, out of sight or in another room.
For more information, checkout www.marmitek.com
Powermid XL Extra IR receiver (Art. nr. 08902 / 09492)
With the help of an extra IR Receiver you can also control your A/V equipment from another
place.
Powermid XL Extra IR transmitter (Art. nr. 08903 / 09493)
With the help of an extra IR transmitter you can also control your A/V equipment from
another place.
EasyIcon 10RF (Art. nr. 09837)
With the help of an EasyIcon 10RF you can control your A/V equipment from another place.
Powermid XL™
Up to 100m free field, up to 25m through walls and ceilings
100 - 240 VAC 50/60 Hz
433.92 MHz
75x80x200mm (with upright antenna)
30-60 KHz.
± 6 metres
5