Frequently Asked Questions (Faqs); Optionally Available; Connecting Multiple Devices; Additional Receiver - Marmitek MegaView 90 Guide Utilisateur

6 Frequently asked questions (FAQs)

Bad (or no) image and sound

Please check that the HDMI source is on.

Use only CAT5e/CAT6 cable as specified in chapter 3 (CAT5e Cable
Requirements).

Check if the CAT5e/CAT6 cable provides a solid connection (no cable
faults).

Check if the RJ-45 has been connected according to the EIA/TIA
T568B standard.

Please ensure that the maximum cable length is not exceeded.

Install your system as far away from any RF sources (wireless devices)
as possible.

Set a low resolution on your HDMI source. The CAT5e/6 cable used
probably cannot deal with the higher resolution bandwidth.
The screen will display the text "Waiting for connection"

When both the
check the cable connections to the transmitter and the sender.

When the transmitter and receiver are connected through a network
(with routers / switchers), and the "DATA" LED is slowly blinking on the
receiver, check the cable connection between the transmitter and the
network.
The screen will display the text ''Please check the TX input signal''

Please check that the HDMI source is on.
Do you have any questions that are not answered above?
Please check www.marmitek.com.

7 Optionally available

7.1

Connecting multiple devices

To connect multiple AV devices to your TV with only one cable or to
transmit the signal of multiple AV devices to your TV, you can you can
choose from a wide range of active switchers. More information about these
so called HDMI Switchers can be found at
7.2

Additional receiver

An additional receiver can be used to connect multiple HDTVs or HD
projectors simultaneously to the same network.
8
'' '' ''
LINK and DATA
''
LEDs are not lit on the receiver,
www.marmitek.com
ai15831451215
© MARMITEK