Programming - Becker VarioControl VC420-II Notice De Montage Et D'utilisation

Intermediate position I
Note
The intermediate position I can be set at any given position and lies be-
tween the upper and lower final positions of the shutter. The intermedi-
ate position I can only be set after the two final positions have been set.
The shutter is adjusted into the intermediate position I from the upper
final position.
Setting the intermediate position I
1. Adjust the shutter from the upper final position into the desired intermediate
position I.
2. Now press and hold the STOP button. Within 3 seconds also press the DOWN
button and keep both buttons pressed.
The shutter will "nod" to confirm.
The intermediate position I has been stored.
Adjusting the shutter into the intermediate position I
1. Press the DOWN button twice within one second.
The shutter will move into the intermediate position I.
Deleting the intermediate position I
1. Adjust the shutter into the intermediate position I.
2. Now press and hold the STOP button. Within 3 seconds also press the DOWN
button and keep both buttons pressed.
The shutter will "nod" to confirm.
The intermediate position I has been deleted.

Programming

de
en
fr
nl
31