Assembly; Programming The Remote Control - Becker Centronic VarioControl VC220h Notice De Montage Et D'utilisation

The VC220h can be mounted for example in or at the head rail of an awning.
Programming the remote control
1. Connect the VC220h to the power supply and the heating element.
2. Now switch on the voltage supply.
3. The VC220h goes into programming mode for 3 minutes.
1) Programming the master transmitter
Press the programming button of the transmitter for 3 seconds while in pro-
gramming mode.
The heating element confirms programming with an optical feedback.
Programming has now been completed.
Note
If a transmitter has already been programmed into the receiver, press
the programming button for 10 seconds.
2) Programming further transmitters
Note
In addition to the master transmitter it is possible to program up to 12
transmitters in the VC220h.
1. Press the programming button of the master transmitter (programmed under
1)) for 3 seconds.
Confirmation occurs via optical feedback.
2. Now press the programming button of a new transmitter which is unknown
to the VC220h for 3 seconds. This activates the programming mode of the
VC220h for a new transmitter for 3 minutes.
3. Now once again press the programming button of the transmitter which is to
be programmed for 3 seconds.
Confirmation occurs via optical feedback.
The new transmitter has been programmed.
16

Assembly