Assembly; Programming The Remote Control - Becker Centronic VarioControl VC220 Notice De Montage Et D'utilisation

Assembly and Operating Instructions
The VC220 can, for example, be assembled in or onto the head rail of a Venetian
blind.

Programming the remote control

1. Connect the VC220 to the power supply and the lighting system.
2. Now switch on the voltage supply.
3. The VC220 goes into programming mode for 3 minutes.
1) Programming the master transmitter
Press the programming button of the transmitter for 3 seconds while in pro-
gramming mode.
The lighting system confirms programming with an optical feedback.
Programming has now been completed.
Note
If a transmitter has already been programmed into the receiver, press
the programming button for 10 seconds.
2) Programming further transmitters
Note
In addition to the master transmitter it is possible to program up to 13
transmitters in the VC220.
1. Press the programming button of the master transmitter (programmed under
1)) for 3 seconds.
Confirmation occurs via optical feedback.
2. Now press the programming button of a new transmitter which is unknown to
the VC220 for 3 seconds. This activates the programming mode of the VC220
for a new transmitter for 3 minutes.
3. Now once again press the programming button of the transmitter which is to
be programmed for 3 seconds.
Confirmation occurs via optical feedback.
The new transmitter has been programmed.
16

Assembly