Programming Additional Transmitters; Deleting Transmitters - Becker VarioControl VC420-II Notice De Montage Et D'utilisation

Assembly and Operating Instructions
Programming additional transmitters
Note
Besides the master transmitter, up to 15 additional transmitters can be
programmed in the VC420-II.
Press the programming button of the master transmitter for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Now press the programming button of a new transmitter which has not yet been
programmed in the VC420II for 3 seconds. This will activate the programming
mode of the VC420II for a new transmitter for a period of 3 minutes.
The shutter/awning/blind will 'nod' to confirm.
Now repress the programming button of the new transmitter you wish to
programme for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
The new transmitter has been successfully programmed.

Deleting transmitters

Deleting transmitters individually
Note
The master transmitter cannot be deleted. It can only be overwritten.
Press the programming button on the master transmitter for 3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Now press the programming button of the transmitter to be deleted for
3 seconds.
The shutter/awning/blind will 'nod' to confirm.
Then repress the programming button of the transmitter to be deleted for
10 seconds.
The shutter/awning/blind will 'nod' to confirm.
The transmitter has been successfully deleted from the VC420II.
28