Explanation Of Functions; Programming The Transmitter - Becker Centronic VarioControl VC360-II Instructions De Montage Et D'utilisation

Prior to charging the batteries using the plug-in power sup-
ply, the solar cell must be disconnected from the control
unit. Attach the yellow terminal to BU (1) and the blue ter-
minal to BN (2). The red charging voltage indicator lamp
lights up during the charging process. The battery is fully
charged after approx. 2 hours.
You can switch between roller shutter / screen operation and venetian blind
operation.
Roller shutter / screen operation (factory setting)
By pressing a travel button, the roller shutter / screen moves to the set limit
position in maintained operation mode.
Venetian blind operation
For venetian blind operation, you can operate the receiver in touch mode. If
you press the travel button for longer than 1 second, the venetian blind runs in
maintained operation mode.

Programming the transmitter

Putting the radio receiver into programming mode
a) Putting the radio receiver into programming mode by switching on
the power
Switch on the power.
▻ The indicator lamp (green) shows the device is ready for program-
ming.
► The radio receiver remains in programming mode for 3 minutes.
b) Putting the radio receiver into programming mode with the program-
ming button
Press the programming button for 3 seconds.
▻ The indicator lamp (green) shows the device is ready for program-
ming.
► The radio receiver remains in programming mode for 3 minutes.

Explanation of functions

29 - en