Din Front/Rear-Mount; Din Front-Mount; Installation With The Rubber Bush; Removing The Unit - Pioneer AVIC-900DVD Manuel D'installation

Installation

DIN Front/Rear-mount

This unit can be properly installed either from "Front" (conventional DIN Front-mount) or
"Rear" (DIN Rear-mount installation, utilising threaded screw holes at the sides of unit
chassis). For details, refer to the following illustrated installation methods.

DIN Front-mount

Installation with the rubber bush

Dashboard
182
53
Holder

Removing the Unit

Pull out to remove the frame.
(When reattaching the frame, point the
side with a groove downwards and
attach it.)
17
After inserting the holder into the dash-
board, then select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
Rubber bush
Screw
Frame
Insert the supplied extrac-
tion keys into the unit, as
shown in the figure, until
they click into place.
Keeping the keys pressed
against the sides of the unit,
pull the unit out.