Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Stainless Steel and Overlay Series
Factory Panels and Kits
(36" [91.4 cm] Models)
All factory parts are available through your KitchenAid dealer or by
calling KitchenAid Parts and Accessories at 1-800-442-9991. In
Canada, call 1-800-807-6777.
Stainless Steel Series 72" (183 cm) Top Grille Panel Kit
A 72" (183 cm) wide Top Grille Panel Kit is available. This kit allows
2 units (one left-hand swing and one right-hand) to be installed
side by side with a single grille.
Stainless Steel (Stainless Steel Series)
Extended Door Handle Kits
Use extended door handles when additional finger clearance is
needed between the door handles and custom panel. Follow the
kit instructions for installing the door handles.
Matte Aluminum (Overlay Series)
Stainless Steel Series Custom Side Panels
Custom side panels may be needed when not enough space is
available to have cabinets on both sides of the refrigerator or
when the refrigerator is placed at the end of a cabinet run. You
may choose an Inset, Flush, or Recessed Inset panel installation.
Refrigerator and Side Trim Dimensions
The width and height of a side panel are determined by the type of
installation you are planning.
NOTES:
The dimensions shown are actual product dimensions and
may not reflect the needed panel installation dimensions.
The side panel should be a minimum of ¹⁄₂" (1.27 cm) thick
to avoid warping.
If the opening depth is 25" (63.5 cm) or more, you may
want to install a support board on the rear wall.
Refrigerator
¹⁄₈
24
"
(61.3 cm)
¹¹⁄₁₆
23
"
(60.3 cm)
¹⁄₂
23
"
(59.7 cm)
Side Trim
#W10153554
Inset Installation Dimensions
#4396718
1. Measure the distance from point A (as shown) to the back
2. If the panel is more than ¹⁄₄" (6.35 mm) thick, rout the front
Flush Installation Dimensions
1. Measure the distance from point A (as shown) to the back
2. Attach the support board with a screw or adhesive that is
Recessed Inset Installation Dimensions
1. Measure the distance from point A (as shown) to back wall.
2. Rout the front edge of the support board or attach a ¹⁄₄"
¹¹⁄₁₆
"
(18.0 mm)
¹⁄₂
"
(12.2 mm)
⁹⁄₁₆
"
(13.9 mm)
(15.7 mm)
wall. Add ⁷⁄₃₂" (5.6 mm) to this measurement to allow the side
panel to fit into the trim.
A
edge to allow the side panel to fit into the trim.
wall.
A
compatible with aluminum and wood.
A
(6.35 mm) board to hold the panel in the cabinet side trim.
⁵⁄₈
"
13
Publicité
Table des Matières
