Setting And Starting A Washing Programme; Interrupting A Washing Programme; Setting And Starting A Washing Programme With Delay Start; Cancelling A Washing Programme - ZANKER ZKV1530 Notice D'utilisation

Do these steps to use the detergent powder again:
1. Fill the salt container and the rinse aid dispenser.
2. Set the water softener to the highest level.
3. Do a washing programme without dishes.
4. Adjust the water softener. Refer to the chapter
'Setting the water softener'.

Setting and starting a washing programme

Set the washing programme with the door ajar.
The washing programme only starts after you
close the door. Until then it is possible to modify the
settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press the programme selection/cancel button
again and again to set the washing programme.
Refer to the chapter 'Washing programmes'.
– The programme indicator light comes on.
4. Close the door.
– The washing programme starts automatically.
When the washing programme operates, you
cannot change the programme. Cancel the wash-
ing programme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.

Cancelling a washing programme

1. Press and hold the programme selection/cancel
button for approximately 3 seconds.
– The programme indicator light goes off.
– The end indicator light starts to flash.
2. Release the programme selection/cancel button to
cancel the washing programme.
At this time you can do these steps:
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent before you
set a new washing programme.
28
5. Adjust the rinse aid dosage.
Different brands of detergent dissolve in different
times. Some detergent tablets do not have the
best cleaning results during short washing pro-
grammes. Use long washing programmes when you
use detergent tablets to fully remove the detergent.

Interrupting a washing programme

Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of inter-
ruption.
Setting and starting a washing programme
with delay start
1. Press the on/off button.
2. Set a washing programme.
– The programme indicator light comes on.
3. Press the delay start button.
– The delay start indicator light comes on.
4. Close the door.
– The countdown of the delay start starts.
– When the countdown is completed, the washing
programme starts automatically.
Do not open the door during the countdown to
prevent interruption of the countdown. When you
close the door again, the countdown continues from the
point of interruption.
Cancelling a delay start:
1. Open the door.
2. Press the delay start button.
– The delay start indicator light goes off.
3. Close the door.
– The programme starts immediately.

End of the washing programme

Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signals for the end of the programme
operate.
1. Open the door.