Programme Selection/Cancel Button; Delay Start Button; Setting Mode; Programme Indicator Lights A And B - ZANKER ZKV1530 Notice D'utilisation

Programme selection/cancel button

Use the programme selection/cancel button for these
operations:
• To set the washing programme. Refer to the chapter
'Setting and starting a washing programme'.
• To set the water softener. Refer to the chapter 'Set-
ting the water softener'.
• To deactivate/activate the audible signals. Refer to
the section 'Audible signals'.
• To cancel a washing programme in progress. Refer
to the chapter 'Setting and starting a washing pro-
gramme'.

Delay start button

Use the delay start button to delay the start of the
washing programme with an interval of 3 hours. Refer
to the chapter 'Setting and starting a washing pro-
gramme'.

Setting mode

The appliance is in setting mode when all the pro-
gramme indicator lights are off and the end indicator
light flashes.
The appliance must be in setting mode for these oper-
ations:
– To set a washing programme.
– To set the water softener level.
– To deactivate/activate the audible signals.
If a programme indicator light is on, cancel the pro-
gramme to go back to the setting mode. Refer to the
chapter "Setting and starting a washing programme".

Programme indicator lights A and B

Apart the selection of the corresponding washing pro-
gramme, these lights have an auxiliary functions:
Indicator lights
The indicator light comes on when it is necessary to fill
the salt container. Refer to the chapter 'Use of dish-
washer salt'.
The salt indicator light can stay on for some hours, but
it does not have an unwanted effect on the operation
of the appliance.
• The adjustment of the water softener level.
• Deactivation/activation of the audible signals.

Audible signals

You can hear an audible signal:
• At the end of the washing programme.
• When the appliance has a malfunction.
The activation of the audible signals is set at the factory.
Do these steps to deactivate the audible signals:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme selection/cancel
button until programme indicator light A flashes
and programme indicator light B comes on.
4. Press the programme selection/cancel button
again.
– Programme indicator light A comes on.
– Programme indicator light B starts to flash.
5. Wait until programme indicator light A goes off.
– Programme indicator light B continues to flash.
– The end indicator light comes on.
The audible signals are activated.
6. Press the programme selection/cancel button
again.
– The end indicator light goes off.
The audible signals are deactivated.
7. Switch off the appliance to save the operation.
Do these steps to activate the audible signals:
1. Do the above procedure until the end indicator light
comes on.
21