Drain Hose; Electrical Connection - ZANKER ZKV1530 Notice D'utilisation

Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in
water.
• If the water inlet hose or the safety valve is damaged,
immediately disconnect the mains plug from the
mains socket.
• Only let the Service Force Centre replace the water
inlet hose with safety valve.

Drain hose

1
Connect the water drain
hose to the sink spigot.

Electrical connection

Warning! The manufacturer is not responsible if
you do not follow these safety precautions.
Ground the appliance according to safety precautions.
Make sure that the rated voltage and type of power on
the rating plate agree with the voltage and the power
of the local power supply.
Always use a correctly installed shockproof socket.
Do not use multi-way plugs, connectors and extension
cables. There is a risk of fire.
Warning! Danger-
ous voltage
2
The waste connection
must be at a maximum 60
cm from the bottom of the
appliance.
3
The internal diameter must not be smaller than the di-
ameter of the hose.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane (A). If you
do not remove the membrane, remaining food can
cause a blockage in the drain hose spigot.
Caution! Make sure that the water couplings are
tight to prevent water leakage.
Do not replace the mains cable yourself. Contact the
Service Force Centre.
Make sure that the mains plug is accessible after
installation.
Do not pull the mains cable to disconnect the appliance.
Always pull the mains plug.
4
33