Carbon Filters; Lighting - ETNA AD570 Série Mode D'emploi

MAINTENANCE

Carbon filters

Lighting

EN 8
Metal grease filters should be cleaned, using a neutral cleaning agent,
either by hand or in the dishwasher on a short, low-temperature
program. Place the grease filters with the openings facing downwards
in the dishwasher so the water can drain out of the filter. Aluminium
grease filters become dull as a result of dishwasher cleaning agents.
This is normal and does not effect the working.
Use carbon filters when the cooker hood is not connected to
an exhaust duct.
1. Open the front panel and remove the grease filter.
2. Centre the carbon filter on the motor frame and turn it to mount it to
the motor frame.
It is necessary to replace the carbon filter every 6 months.
Note
• More noise is produced when carbon filters are used than when the
cooker hood is used with an exhaust vent.
• Carbon filters function optimally at a lower motor speed. For this
reason, avoid the intensive setting.
• Saturation of the carbon filter will eventually occur after more or
less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• Do not wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly, change the filter regularly.
• Dispose of the old carbon filter properly, with non-recyclable waste.
This hood is fitted with a light system. This light system has to be
replaced by an authorized technician. Do not attempt to replace it
by yourself.
The lamp in this household appliance is only suitable for
illumination of this appliance. The lamp is not suitable for
household room illumination.