Height Adjustment; Fill Quantity; Child Lock - Bosch Filtrino THD20 Série Mode D'emploi

en
Set the on/off switch to on. All display
►
items will light up briefly, and then the
90°C icon stays lit.
Place a glass or cup holding at least
►
150 ml on the cup stand under the water
outlet.
Press the start/stop button to dispense
►
one portion of water to rinse the
appliance.
Note: Before using the appliance for the
first time or after a long period of non-use,
do not drink the first two glasses of water.
The machine is now ready to use.
Dispensing water
Set the cup stand to the appropriate
►
height for the cup or glass.
Place the cup or glass under the water
►
outlet.
Press the temp. set button to select the
►
desired temperature.
Press the start/stop button. The water
►
will dispense from the outlet.
The s elected temperature flashes while
the water is dispensed.

Height adjustment

The adjustable cup stand lets you adjust
the distance between your cup or glass and
the water outlet. The lowest setting is suit-
able for taller glasses and cups. For smaller
cups or soup cups you can insert the cup
stand into one of the upper openings.
Important: Donʼt use the appliance without
the cup stand.

Fill quantity

The appliance ships with a preset fill
quantity of 120 ml. You can change this
quantity.
To adjust the fill quantity, proceed as
follows:
Hold down the temp. set button for at
►
least 5 seconds.
The indicator for the currently set fill
►
quantity flashes.
Press the temp. set button to select the
►
desired fill quantity:
L
= approx. 120 ml
70 °C = approx. 150 ml
80 °C = approx. 200 ml
90 °C = approx. 250 ml
Q
= approx. 300 ml
Press the start/stop button – the setting
►
is now stored.
Important: To keep the dispensed water
from overflowing, make sure that you place
a sufficiently large glass or cup under the
water outlet.
Note: To change this setting at any time,
repeat the above procedure.

Child lock

For safety reasons, this appliance is
equipped with a child lock. To activate it,
proceed as follows:
Press and hold the temp. set and start/
►
stop buttons simultaneously for at least
5 seconds. The L and P icons light up .
Info: When the child lock is activated, only
ambient water is available. When you press
the temp. set button, the L flashes; all
other settings are blocked.
To deactivate the child lock, proceed as
follows:
Press and hold the temp. set and start/
►
stop buttons simultaneously for at least
5 seconds. The P icon goes out.
17
THD20.. | 05/2014