Title Programming; Relay Function - MC Crypt CDMP-68U DJ Notice D'emploi

10. Commissioning

Title Programming

• To start programming, the CD player must be switched to pause and track selection mode. If folder selection
was activated (the display shows "FOLDER"), programming cannot be activated.
• Push the PROG button (5). "P-01" will be displayed. The display "PROG" flashes.
• Use the button FOLDER (4) and the dial TRACK (3) to select the corresponding title.
• Push the dial TRACK (3) to store the title. "P-02" flashes in the display.
• Select the button FOLDER (4) and the dial TRACK (3) to select the next title.
• Push the dial TRACK (3) to store this title. "P-03" flashes in the display.
• Repeat the individual steps of track selection and storage until all desired tracks were stored. Push the
TRACK (3) dial again to complete programming.
Turn the dial TRACK (3) to display all stored titles in sequence or push the dial TRACK (3) to return to
programming.
• Start programming playback with the PLAY/PAUSE button
play.
• Terminate playback of the programming with the PLAY/PAUSE
PROG (5) to return to normal playback. The programming remains stored.
Push the button PROG (5) in pause mode to open the programming again. Select and save other titles
to expand the programming, start programming playback by pushing PLAY/PAUSE
the PROG button(5) down for approx. 2 seconds to delete programming.

RELAY Function

In this function, alternating playback between two CD players is started. This means that playback of one CD drive
is started when the other has stopped playing back a title/CD.
• Activate or deactivate the RELAY function by pushing the REPLAY button (6). The button lights up when the
RELAY function is activated.
The two CD players must be connected by the RELAY socked (4) and support this function.
4
(14). The display "PROG" flashes in the dis-
(14) button. Push and hold the button
(14) or keep