How To Prepare Machine For Operation - Clarke Ultra Speed Burnisher 120 Manuel D'utilisation

HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install the Pads
WARNING: Always remove the electrical
plug from the electrical outlet
before installing or changing
the pad.
The pad driver assembly is on the bottom underside
of the machine. The pad holder holds the pad in
position. The machine has a screw-on pad holder.
To install the pad, follow this procedure:
1. Lock the handle in the verticle position.
2. Position the handle on the floor, so that the machine
is laying on its back. See Figure 2.
3. Unscrew the pad holder (A).
4. Carefully center the pad on the pad driver (B). Failure
to center may cause vibration and operator fatigue.
5. Screw the pad holder (A) into position.
6. Return the machine to an upright position.
Clarke ® Operator's Manual (EN) - Ultra Speed Burnisher
ENGLISH
EN
A
↑
B
Figure 2
- 7 -