Clarke Ultra Speed Burnisher 120 Manuel D'utilisation page 6

ENGLISH
EN
240 VOLT MACHINES
Instructions for connection to the power
supply and the electrical ground.
This product must be grounded. If the installation
should breakdown, grounding provides a path of low
resistance for electric current to reduce the risk of
electrical shock. This product is equipped with a
cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
WARNING: Improper connection of the
equipment-grounding conductor can re
sult in a risk of electric shock. Check
with a qualified electrician or service
person if you are in doubt as to whether
the outlet is properly grounded.
This product is for use on a nominal 240 volt circuit.
The plug on this product must be replaced with a
three contact grounding style plug, having a
configration appropriate for connection to the local
power supply. The new plug must be installed by a
qualified electrician.
WARNING: To prevent possible electric
shock, protect the machine from rain.
Keep the machine in a dry building.
WARNING: To prevent possible electric
shock, always use a 3-wire electrical
system connected to the electrical
ground. For maximum protection
against electrical shock, use a circuit
that is protected by a ground fault circuit
interrupter. Consult your electrical
contractor.
WARNING: Do not cut, remove or break
the ground pin. If the plug does not fit
your outlet, consult your electrical
contractor.
WARNING: Have worn, cut or damaged
cords replaced by an authorized service
person.
EXTENSION CORDS
Use only an approved extension cord with three
conductors, a plug with three terminals, and a
connector body with three holes. The machine has a
power cord with wire size 14 AWG.
WARNING: If you use an extension
cord, use an extension cord with
minimum wire size 12 AWG. Do not use
an extension cord longer than 50 feet.
Do not join two extension cords.
-6- Clarke ® Operator's Manual (EN) - Ultra Speed Burnisher