OHAUS TD52 Manuel D'instruction page 8

EN-6
4. Disassemble the cable gland by loosening the cap nut and removing the rubber seal.
Pass the relay output through the cap nut, then spread the rubber seal and place it over
the cable. Now pass the cable through the body of the cable gland.
5. Connect the cable to the relay board 12 pin connectors. Install the relay board. Secure it
with 2 screws. (Note: boss post is 5 and 7.). Put the relay cable through the M25 hole.
Connect it to the 3 pin and 6 pin connectors.
M25 Gland
Cap Nut
Cable
Ferrite
Main board connector 2
Relay Output Cable