OHAUS TD52 Manuel D'instruction page 7
Masquer les pouces
Voir aussi pour TD52:
- Manuel d'instruction (148 pages) ,
- Mode d'emploi (56 pages) ,
- Manuel d'instruction (80 pages)
Publicité
Les langues disponibles
Les langues disponibles
7.
Put the interface option cover back on the terminal.
For TD52XW:
1.
Remove the interface option cover. Remove the 6 screws with sealed washers. Remove
the M25 hole plug as shown.
2.
Rotate the rear housing down away from the front housing as shown.
3.
Connect the cable to the main board connector 2. Place the ferrite in the slot of the
internal cover as shown.
Screw
Load cell cable male
connector
M25 Hole plug
EN-5
Publicité
