OHAUS TD52 Manuel D'instruction page 12
Masquer les pouces
Voir aussi pour TD52:
- Manuel d'instruction (148 pages) ,
- Mode d'emploi (56 pages) ,
- Manuel d'instruction (100 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN-10
4.
Connect the cable to the relay board 12 pin connector. Install the relay board. Secure the
relay board with 2 screws (Note: the boss post is 6, 8).
5.
Disassemble the cable gland by loosening the cap nut and removing the rubber seal.
Pass the relay output through the cap nut, then spread the rubber seal and place it over
the cable. Now pass the cable through the body of the cable gland.
6.
Put the relay cable through the M25 hole. Connect it to the 3 pin and 6 pin connectors.
M25 Gland
Cap nut
Boss post 6,8
12 Pin connector
Ferrite
Screw
Relay output
Publicité
Table des Matières
