English - Geberit AQUACLEAN MERA Instructions De Montage

Adjusting basic settings
to customer's wishes
Comfort model
The basic settings of the device are set
from the rear of the remote control.
The following steps are shown in shortened
form. See user manual for an overview of
the complete menu.
Prerequisite
– The function test of the device was performed
successfully.
– Function test of the remote control was
performed successfully.
1
Launch [Basic settings] main menu via the
<left>/<right> arrow key.
Basic settings
Select submenus with the <up> and <down>
arrow keys. Configure settings with the
<left> and <right> arrow keys.
2
Launch the [Select language] menu. Set the
menu language.

English

3
Launch the [Water hardness] menu. Set the
hardness value in accordance with the local
water hardness.
Water hardness
hard
Range
soft
medium
hard
Set to [hard] if you do not know the local
water hardness.
126100791724687115-1 © 04-2020
970.058.00.0(00)
4
Launch the [System flush] menu. Configure
switch-on behaviour.
System flush
off
✓ [on] = The system flush starts as soon as
a user is detected on the WC.
✓ [off] = The system flush starts before the
shower procedure as soon as the
<Shower> button is pushed. The flush
time before the shower procedure is
approx. 15 seconds.
5
Launch the [Orient. light colour] menu. Set
colour.
Orient. light colour
white
If Geberit Monolith Plus is installed, select
the same colour.
6
Launch the [Orient. light bright.] menu. Set
brightness.
Orient. light bright.
7
Launch the [Orientation light] menu.
Configure switch-on behaviour.
Orientation light
on approach
8
Launch the [WC lid detect. range] menu. Set
the sensor range.
WC lid detect. range
✓ Reliably detects the user.
The sensor must be configured so that the
WC lid does not lift up unintentionally.
9
Launch the [Basic settings] menu.
Basic settings
Result
✓ The settings are saved.
✓ The device is installed correctly.
on
EN
47