Geberit AQUACLEAN MERA Instructions De Montage page 39

3
Close design cover.
Result
✓ The LED on the lateral control panel lights up
blue.
✓ The device is ready for operation.
If the status LED flashes red:
• Test whether the water supply has been
established. Open ball valve.
• Reset storage water heater. → See
"Resetting the storage water heater",
page 44
• switch off device, wait 30 seconds and
then switch device back on.
If the status LED continues to flash red
after taking these measures, contact
customer service.
126100791724687115-1 © 04-2020
970.058.00.0(00)
Putting the remote control into
operation
If several devices of the same type are
installed in immediate proximity (e.g. in
hotels), remote control must be assigned.
→ See "Re-assigning the remote control",
page 40.
Prerequisite
– Function test of the device was performed
successfully.
▶
Open the battery compartment and insert
battery.
Result
✓ The display shows [Pairing ok] for 10 seconds.
If the [Pairing ok] message does not
appear, re-assign remote control. → See
"Re-assigning the remote control",
page 40.
EN
39